Add To Cart. Click to enlarge. Requires: Model airplane fuel Building and Field Equipment Charging Rx and Tx batteries with included charger for 12 hours each Features: Construction: Balsa and plywood Wings: CenterCore Molded Composite Main Wing Rib maintains perfect alignment and includes a built-in aileron servo mount, wing halves are joined with a steel rod. Flat bottom high mount configuration One-piece, all wood precision airfoil with SpinControl Airfoil Extensions provide lift even in a stall to keep the NexSTAR level and the pilot in control.
PivotFlex Wing Mounting System fastens with one nylon bolt, a rubber retainer and pivoting channel absorb minor jolts of normal use, more severe jolts cause the wing to separate from the fuselage and escape the full force of impact. Airspeed Restrictor: SpeedBrakes Training Flaps attach to forward section of wing near fuselage and hold airspeed to a minimum to insure smooth landings, removeable as pilot skills increase Covering: Polyester based heat shrink, color scheme is White and Red with Silver accents.
Toy Hobbico starfire 40 User Manual Almost-ready-to-fly radio controlled model airplane 24 pages. In that Hobbico has no control over the final assembly or material used for final assembly, no liability shall be assumed nor accepted Include a letter stating your name, return shipping address, as Your NexSTAR Select should not be considered a toy, but rather a sophisticated, working model that functions very much like a full-size airplane. Page 4: Isosmooth Engine Mount Administration to help light airplanes prevent stalls and spins during landing approaches.
They slow down the airplane, increase its stall resistance and prevent it from spinning, all desired characteristics of a trainer airplane. The wing Page 5: Speedbrakes Training Flaps The SpeedBrakes Training Flaps were designed to allow your with the fuselage and fin while tightening the tail bolts. The NexSTAR Select to fly slower, reduce top speed and shorten tail bolts slide into blocks in the fuselage under the the landing approach. Simulators are a great learning tool because they allow you Page 8: Install The Landing Gear 3.
Install the other flap onto the other wing using three halves together. The wing is now complete. Install the other landing gear leg on the other side of the fuselage the same way. Once they are both installed, apply a light force to pull them out. Page 10 4. Tighten the bolts until they fit snug against the bottom of the fuselage. Note: Over tightening these bolts will damage the nylon threads and it may cause in flight failure.
Do not over tighten these bolts. Insert the vertical stabilizer into the fin slot as shown above. You must carefully perform all of the following Setup procedures.
If possible, have your flight instructor assist. If you have not yet charged the batteries, you may still proceed. Page 12 4. The pushrods should also be installed correctly into the control horn. Remember that in step 5, page 10, the rudder and elevator control rods were installed on the rudder and elevator control horns using the second hole from the servo arm center.
Move the right stick down and observe the direction the elevator moves. This system uses on-board electronic sensors that detect instability-just release the sticks and AFS does the rest. Sensitivity is adjustable as pilot gains flight skills. Landing Gear: Duraluminum SnapGear Quick Landing Gear Mounts lock in place with a snap and provide the strongest landing gear of any trainer, also easily removeable Aileron Control: Single standard size servo, wings are built with dual aileron servo trays for future upgrades as skills increase, can also be equipped with flaps Tail Mounting: EasyAlign System guides parts into place automatically in perfect alignment without tools Propeller: 11x5 nylon, black in color with painted tips to aid visibility-available separately, HCAA Building Time: Ready to fly in only 20 minutes Warranty Period: Hobbico guarantees this kit free from defects in both material and workmanship at the date of purchase.
This warranty does not cover any component part damaged by use or modification.
0コメント